Installation of the monitor:
1. Use the Suction Cup to install the monitor. The Suction Cup is stamped
on the front window glass.
2. Connect power of the monitor. There are two methods as
below:
A: According to the same steps, find power from the car power
circuit in front, and connect the cables correctly.
B: Use the Cigarette Lighter Adapter included in the package to
get the power form cigarette lighter socket
2
1
6. A detector to find the power:
how to find the power from the reverse light?
Instructions: black clamp connects to the ground wire. Use
the red pen to find the power from the reverse light until the
LED light is on. Then connect our red power line to the power
from the reverse light, and the black to the ground wire.
A detector
to find
the power
2P
Red wire
Black wire
Reverse
light
Ground
1
2
3
4
In-line Wire Connector Instructions
The camera can be wired directly to the reverse light circuit by
stripping the reverse light wires and then twisting the camera
wires to the exposed reverse light wires. Once they are connected,
wrap them with electrical tape. Do not attempt this if you are not
knowledgeable with electrical installation practices.
1.Insert the existing
wire to be tapped.
2.Insert the wire
to be attached.
3.Crimp tap and
then close lock
5.Find and connect the reversing light cable with proper
positive and negative electrodes.
6.Stand on the rear of the vehicle with a board(30X100cm)strait
stood on hand, reverses slowly to verify the function.
3. Connect the camera and wireless Transmitter Box.
4. Install the box on the side of the trunk.
Pairing the system
3
4
5
6
