14
Putting into operation
Sprühboy 08s - Airless Edition 02.13
4.3
Fill the Sprühboy 08s with the
required agent pressure
It is imperative that you comply with the
chapter "General requirements on the
compressed air source", page 12.
The external compressed air source
must supply a minimum pressure of 5
bar.
The desired spray pattern determines
the required agent pressure. The agent
pressure is set via the turning knob (1)
at the pressure reducer (2).
The agent pressure must be at least
5 bar to result in a reasonable spray
pattern
The bleed valve (3) opens if the
maximum
permissible
implement
pressure of 6 bar is exceeded (3).
- Connect the compressed air supply (4) to an
external compressed air source.
The external compressed air source fills
the Sprühboy 08s with compressed air.
The manometer (5) indicates the current
agent pressure.
- Read off the set agent pressure at the manometer
(5).
- Change the indicated agent pressure at the
turning knob (1), if the manometer (5) does not
indicate the required agent pressure (at least 5
bar).
To change the agent pressure, slightly
pull out the turning knob (1) and turn it
into the desired direction.
•
To increase the agent pressure - turn
the turning knob clockwise (+).
•
To reduce the agent pressure - turn
the turning knob anti-clockwise (-).
