Boyens Backservice Jelly power pack, Instruction Manual

Page: 23 / 44

Putting into operation
23
Jelly power pack Edition 09.09
4.12 Restarting after an operational
break
- Press the on-/off switch (1).
- It will flash:
•
the red temperature-control light (3) and
•
the temperature display (3).
The temperature display shows the
current system temperature.
When the red temperature-control light
(2) has gone out the implement is ready
for operation again.
We recommend this procedure because
the jelly will lose its ability to jelly after 2
- 4 hours of stale.
It the operational breaks will last longer
than 3 hours, this procedure is only
permitted in exceptional cases. If the
system will not be sprayed empty after
such a long operational break, material
burns inside the system may be the
result.
The system had been sprayed empty before the
operational break:
- Connect the implement to an external
compressed air source.
- Take the spray gun out of the retainer.
- Protect the spray gun against unintended spraying
by turning the locking device.
- After the agent-feed-pump has delivered the jelly
up to the agent-nozzle of the spray gun, you may
start to spray your products.
The system had not been sprayed empty before
the operational break:
•
The operational break lasted less than
3 hours:
- Connect the implement to an external
compressed air source.
- Take the spray gun out of the retainer.
- Protect the spray gun against unintended
spraying by turning the locking device.
- Now you may start to spray your products.
•
The operational break lasted longer than
3 hours:
- Connect the implement to an external
compressed air source.
- Take the spray gun out of the retainer.
- Protect the spray gun against unintended
spraying by turning the locking device.
- Spray approx. 300 ml jelly into a bin/bucket
before you start to spray your products.