Drill
1
⁄
2
" (12mm) holes
toggle wings
Level bracket
before hanging
speaker
6-32 x 2"
machine screws
2. Drill all holes as indicated. Insert the
machine screws through the bracket and
thread them onto the toggle wings before
penetrating the wall. Push the toggle wings
through the holes in the wall.
3. Level the bracket and tighten the screws.
Connect the wires to the terminals and hang
the speaker on the brackets, so the DIRECT
or DIFFUSE arrow on the label points to the
front of the home theater area according to
your preference.
MOUNTING
1. Mark off the two bracket mounting holes
using the VRX Mounting Template provided.
If running wires behind the wall, then also
mark off a
1
⁄
2
"
(12mm) hole located at 2
1
⁄
2
"
(63mm) below the lower bracket hole. This
hole is also positioned on the template.
2"
(51mm)
2
1
⁄
2
"
(63mm)
