Boss RC-600, Parameter Manual, Page: 5 / 48

5
Memory Settings (LOOP)
Parameter Value
(Bold: default)
Explanation
LOOP LENGTH
Specifies the length to which LOOP SYNC (p. 3) aligns the beginnings of the material for loop sync.
AUTO
The length of the first-recorded phrase will be the LOOP LENGTH.
1–25362 Manually specifies the number of measures that will be looped.
SPEED CHANGE
Specifies the timing at which the playback speed switches to the speed set in TEMPO SYNC SPEED (p. 3).
IMMEDIATE
The change will occur immediately.
LOOP END The change will occur after playback has reached the end of the loop.
SYNC ADJUST
When SPEED CHANGE is set to “IMMEDIATE,” this sets the conditions for synchronizing the start of the tracks.
MEASURE
The starting points of the tracks are synchronized if they are out of alignment by one measure
or less.
BEAT
The starting points of the tracks are synchronized if they are out of alignment by one beat or
less.
INPUT FX
BANK A–D
Parameter Value
(Bold: default)
Explanation
FX A–D
OFF
, ON
Specifies the FX A–D on/off.
* When MODE is set to “SINGLE,” you can turn on only one effect from A–D.
BANK
A –D Sets the target FX bank for operating and editing.
SW
OFF
, ON Specifies the FX bank on/off.
MODE
This sets whether multiple effects can be activated at once for FX A–D.
SINGLE
Only one effect can be turned on.
MULTI
Multiple effects can be turned on at the same time.
FX TARGET
A
–D
This sets for which effect out of FX A–D the intensity is controlled using the external
expression pedal.
FX A–D
Parameter Value
(Bold: default)
Explanation
SW
OFF
, ON Specifies the effects on/off.
SW MODE
This configures how the switch works when switching between the onboard switches and external footswitches for FX
A–D.
* The functions for the onboard switches and external footswitches are configured in “CTL FUNC” (p. 14).
TOGGLE
The effect toggles between on and off with each press of the switch.
MOMENT
The effect turns on only while the switch is pressed.
INSERT
These parameters set the inputs for which effects are applied.
* When STEREO LINK is “ON,” the L/R channels of MIC 1, 2 are shown as a single connector.
ALL
Applies effects to all inputs.
* Even when this is set to “ALL,” the unit doesn’t record inputs with effects if the LOOP/TRACK
1–6 INPUT (p. 4) for all the tracks hasn’t been set to “ON.”
MIC1, MIC2 Applies effects to the input audio from the MIC 1, 2 connectors.
INST1-L, INST1-R Applies effects to the input audio from the INST 1 L/MONO, R jacks.
INST2-L, INST2-R Applies effects to the input audio from the INST 2 L/MONO, R jacks.
FX TYPE
Select the type of effect to assign to the FX A–D, and set their FX parameters.
* The FX parameters vary depending on the selected effect type.
&
“Input FX/Track FX List” (p. 36)