71
Chapter 4 Creating User Songs
4
■
Use [Maj] through [9th] to specify the chord type.
* You cannot select a chord type other than [Maj] through [9th].
■
To specify an On-Bass chord, hold down [SHIFT] and
use [C] through [B] and [#/
b
] to specify the bass tone.
5.
Press [START].
The Chord’s Realtime Recording screen is displayed. The
Form being recorded begins to play, and recording
begins with the Chord input at Step 4.
* When the count-in is selected, the count-in is indicated in the
left of the display while the count sound plays. After the count-
in is displayed, recording begins.
fig.RE04-18
6.
Record the next Chord.
■
Use [C] through [B] and [#/
b
] to specify the root of the
chord.
■
Use [Maj] through [9th] to specify the chord type.
To input both the chord root and type, press both buttons
simultaneously.
For example if you wish to record “CMaj” after “E7th,” press
[C] and then press [Maj] to record “C7th” and “CMaj.”
* You cannot select a chord type other than [Maj] through [9th]
while the song is being played.
7.
Repeat Step 6 as needed.
8.
Once you have finished recording the Chord, press
[STOP].
[REC] goes dark, and the Chord screen appears.
* Press [SONG] to display the song screen.
Step Recording
1.
Display the Chord’s Record Standby screen (p. 66).
[REC] and [CHORD] lights up.
2.
Press [REC] to display “STEP.”
Step Recording is selected.
fig.RE04-43
3.
Use [CURSOR] and [VALUE] to set the Quantize.
The
Quantize
here sets the timing to the selected note
length of the subsequent step when [FWD] or [RWD] is
pressed in later operations.
fig.RE04-06
4.
Press [START].
The Chord’s Step Recording screen is displayed, and
recording begins. [REC] lights up.
fig.RE04-20
5.
Move to the timing (measure/beat/clock) to be used in
recording the Chord.
■
Press [FWD] to set the Quantize so that the timing is
synchronized to the subsequent step; Press [RWD] to
synchronize the timing to the previous step.
* You can change the Quantize value by pressing [CURSOR]
and then turning [VALUE] to make the Quantize display
flash.
6.
Record the Chord.
■
Use [C] through [B] and [#/
b
] to specify the root of the
chord.
Pressing [#/b] repeatedly cycles through the selections of
“#,” “b,” and “none.”
* Depending on the root of the chord, the symbols that can be
selected may differ.
If you press [CURSOR
] to select “1 COUNT IN,”
you can make count-in settings. (p. 60)
Display
Quantize
Display
Quantize
Half note
Quarter note triplets
Quarter note
8th note triplets
8th note
16th note
Whole note
Half note triplets
Quantize
Clock
Beat
Octave Shift
