Boss Snowplow RT3 DXT, Installation Instructions Manual

Page: 23 / 36

Important:
Use the D-Force feature only
while back dragging to prevent damage to
the plow or vehicle.
•
Left Wing Out button—moves the left wing out
•
Right Wing Out button—moves the right wing out
•
Left Wing In button—moves the left wing in
•
Right Wing In button—moves the right wing in
•
Sleep mode—If you do not use the controller for
20 minutes, it enters sleep mode and the controller
lights flash green and red. Turn the controller off
and on again to deactivate the sleep mode.
To perform different tasks, you can configure the plow
wings as follows:
•
To angle the entire plow blade right, press the
Right Wing In and Right Wing Out buttons
simultaneously until the blades are fully angled.
•
To angle the entire plow blade left, press the Left
Wing In and Left Wing Out buttons simultaneously
until the blades are fully angled.
•
To make the scoop shape with the plow, press
the Left Wing Out and Right Wing Out buttons
simultaneously until the blades are fully extended.
•
To make the “V” shape with the plow, press the Left
Wing In and Right Wing In buttons simultaneously
until the blades are fully retracted.
Specifications
Note:
Specifications and design are subject to change without notice.
Blade width Material Blade height Recommended push
beam height Weight
Stainless Steel 417 kg (920 lb)
Poly 398 kg (878 lb) 2.49 m (98 inches)
Mild Steel
95 cm (37-1/2 inches)
394 kg (868 lb)
Stainless Steel 433 kg (977 lb)
Poly
424 kg (935 lb) 2.79 m (110 inches)
Mild Steel
98 cm (38-1/2 inches)
39.3 cm (15-1/2 inches)
420 kg (925 lb)
3.05 m (120 inches) Mild Steel 114 cm (45 inches) 41.9 cm (16-1/2 inches) 546.5 kg (1,205 lb)
23