g321677
Figure 26
1.
Coupler tower
3.
Lower pin
2.
Wire harness
4.
Disconnect the plow wire harness from
the vehicle wire harness and secure the
electrical-plug dust-covers.
5.
Slowly back the vehicle away from the snowplow.
Adjusting the Plow
Use this procedure to adjust the blades to sit level
with the ground.
g321722
Figure 27
1.
Long bolt
3.
Short bolt
2.
Bumper stop bracket
4.
Center adjustment bolts
Raise and lower the plow in the V position. If the
blades digs into the ground, the center adjustment is
too low.
Place the plow in the scoop position. If the blades do
not sit level, the center adjustment is too high.
1.
Lower the blades, stop the machine, set the
parking brake (if equipped) or chock the wheels,
and remove the key.
2.
Loosen the long bolt and nut.
3.
Remove the short bolts and nuts.
4.
Raise or lower the bumper stop bracket using
the center adjustment bolts.
If the plow does not sit level with the ground
after adjustment, change the pushbeam height
on the vehicle.
17
