3.
Clean the location with the provided alcohol
wipe and dry it with a cloth or paper towel.
4.
Clean the back of the swivel mount (
with the alcohol wipe and then dry it.
g032942
Figure 15
1.
Swivel mount
2.
Mounting tab
5.
Remove the backing from 1 side of the adhesive
and apply it to the back of the swivel mount.
6.
Remove the remaining backing from the
swivel-mount adhesive and press the swivel
mount to the clean area of the dashboard for 30
seconds.
Important:
Once the mount is placed, you
cannot remove it without destroying the
adhesive.
7.
Clean the back of the controller with the alcohol
wipe and then dry it.
8.
Remove the backing from 1 side of the adhesive
and apply it to the back of the mounting tab
(
).
9.
Remove the remaining backing from the
controller adhesive and press the mounting tab
to the controller for 30 seconds.
10.
Let the swivel mount rest unused for 72 hours
before sliding the controller into the mounting
bracket.
Important:
Mounting the controller
immediately may cause the adhesive to fail.
Installing the Wire Harness
DANGER
Vehicle engines contain moving parts and can
become extremely hot, capable of causing
severe burns and serious bodily harm.
Shut off the engine and allow it sufficient time
to cool down before installing this kit.
DANGER
Vehicle batteries can cause dangerous
electrical shocks that could lead to severe
burns or death.
Disconnect your battery before installing this
kit.
Note:
Apply dielectric grease to all electrical
connections.
1.
Park the machine on a level surface, shut off the
engine, wait for all moving parts to stop, engage
the parking brake, and remove the key from the
ignition switch.
2.
Mount the vehicle-side, wire-harness plow
connector to the left side of the front bumper
using the control-harness mounting-bracket and
2 cap screws and self-locking nuts.
Note:
Drill 2 holes in the front bumper to mount
the bracket.
3.
Mount the power/ground connector to the control
harness mounting bracket.
g037975
Figure 16
1.
Self-locking nut
6.
Control harness mounting
bracket
2.
Power/Ground connector
bracket
7.
Plow connector
3.
Long bolt
8.
Short bolt
4.
Power/Ground dust cap
9.
Control harness dust cap
5.
Power/Ground connector
4.
Secure the dust caps to the wire harness plugs
and mounting bracket.
12
