en
operation
32
▶
Press and hold
记忆
for approx. 3
seconds.
Press
记忆
to call up the saved
programme.
Note:
To overwrite the saved pro-
gramme, repeat the steps above.
14.5 Loading laundry
Note:
To prevent creasing, take note
of the maximum load for the
→
Requirement:
The laundry is pre-
pared.
→
1.
Open the door.
Make sure that the drum is empty.
2.
Place the laundry in the drum.
3.
Close the door.
Ensure that there is no laundry
trapped in the door.
14.6 Adding detergent and
care product
Note:
Observe the information about
1.
Pull out the detergent drawer.
2.
Pour in detergent.
→
3.
If required, add the care product.
4.
Push in the detergent drawer.
14.7 Starting the programme
Note:
If you want to change the time
until the programme ends, set the
"Ready in" time first.
1.
Press
.
a
The display shows either the pro-
gramme duration or the "Ready in"
time.
a
After the programme has ended,
the display shows: End.
2.
If is selected, the laundry is not
spun and the water is drained after
rinsing.
Notes
¡
If the laundry is not removed, the
Anti-Crease programme starts after
15 minutes. The programme takes
around 30 minutes. The display
shows
00:00
and appears.
Press anywhere on the display to
cancel the Anti-Crease programme
and to remove the laundry.
¡
If "Hot" appears, the appliance
cools the laundry.
When "Hot" goes out, the laundry
has cooled down.
14.8 Adding laundry
1.
Press
.
During the washing cycle, the ap-
pliance pauses.
During the drying cycle, the appli-
ance checks whether it is possible
to add laundry.
Note:
If appears, it is not pos-
sible to add laundry.
When goes out, it is possible to
add laundry.
2.
Open the appliance door.
3.
Add or remove laundry.
4.
Close the appliance door.
5.
Press
.
14.9 Cancelling the pro-
gramme
1.
Press
.
2.
Open the appliance door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the programme.
Summary of Contents for XQG100-WDU285H80W
Page 55: ......
