en
Faults and what to do about them
46
Faults and what to do about them
hot
The door cannot be opened after the drying programme due to the high tempera-
ture. The cooling process continues until the display disappears, after which the
door can be opened.
¹
■
Flashes
(no water supply): Tap turned on? Water inlet filter blocked? Clean
Water hose kinked or blocked?
■
Lights up
(low water pressure): For information only. This will not affect the
programme progress. The programme duration is extended.
E:18
Drain pump blocked; clean the drain pump. Clean the drainage hose
on the siphon.
ªªª
■
Hold down button
5
(Drying)
for 3 seconds to delete the display.
■
Clean the air filter.
■
Run the
Fluff Clean
l
Ž
(cold) programme without laundry.
LO kg
,
HI kg
Laundry amount information. On when drying phase finished.
LO kg
: Signals a small load for drying,
HI kg
: Signals a very high load for drying.
Other displays
Turn the programme selector to
Ú
Off
. The appliance is switched off. Wait 5 s
and switch on again. If the display is indicated again, call customer service.
Faults
Cause/Remedy
Water is running out.
■
Correctly attach/replace drainage hose.
■
Tighten screw-fitting on the supply hose.
Water not flowing in.
Detergent not dispensed.
■
A
(
Start
/Reload)
not selected?
■
Tap not open?
■
Filter blocked? Clean the filter
■
Supply hose kinked or jammed?
The washing machine
door cannot be opened.
■
Safety function active. Stop programme?
■
$
(Rinse stop = without final drain/spin) selected?
■
Can be opened with emergency lock release only?
■
Childproof lock active? Deactivate.
Programme does not
start.
■
A
(
Start
/Reload)
or
5
(
Finish in
) selected?
■
Door closed?
Detergent solution is not
drained.
■
$
(Rinse stop = without final drain/spin) selected?
■
Clean the drain pump.
■
Clean outlet pipe and/or drainage hose.
Water not visible in the
drum.
Not a fault – water below the visible area.
Display
Cause/Remedy
Summary of Contents for WVH28422SN
Page 51: ...6 ...
