Operating the appliance
en
33
End of the programme
– 0 –
or
– – – –
(
Rinse stop
= without
final drain/spin cycle) is indicated in the
display and acoustic signal sounds.
Setting the signal
If
$
(
Rinse stop
= without final drain/
spin cycle) was selected, press
A
(
Start
/Reload) button to start the final
drain/spin cycle.
Notes
■
The programme continues by
pumping out the water and spinning
the laundry (the standard spin speed
can be changed beforehand).
■
If only the water is to be pumped out,
approx. 1 minute after the
programme starts, touch the
A
(Start/
Reload
) button before the spin
cycle starts, then turn the
programme selector to
Ú
Off
. The
programme is interrupted and the
door lock is released. The laundry
can be removed.
■
If
hot
flashes in the display before
the drying programme ends, the
temperature in the drum is high. The
programme for cooling the drum
runs until the temperature in the
drum has dropped.
After washing/drying
1.
Open the door and remove the
laundry.
2.
Turn the programme selector to
Ú
Off
. The appliance is switched off.
3.
Turn off the tap.
Not required for Aqua-Stop models.
Notes
■
Do not leave any items of laundry in
the drum. In the next wash they may
shrink or discolour another item.
■
Remove any foreign objects from
the drum and the rubber seal – risk
of rust.
■
Leave the detergent drawer and
door open so that residual water can
evaporate.
■
Always remove the laundry.
■
Always wait until the programme
ends, as the appliance could still be
locked. Then switch the appliance
on and wait for the unlocking device.
■
When the display panel has gone
out at the end of the programme,
energy-saving mode is active. To
activate the display again, select any
button.
Summary of Contents for WVH28422SN
Page 51: ...6 ...
