en
Installation and connection
16
Connection on right side
Note:
If the hose holders are used, the
possible hose lengths are reduced!
Available from dealer/customer
service:
■
Extension for Aqua-Stop or cold
water inlet hose (approx. 2.50 m).
Order no. WMZ 2380, WZ 10130,
CZ 11350, Z 7070X0.
■
Longer supply hose (approx.
2.20 m), for standard model.
Connecting the water
:
Warning
Risk of electric shock!
Danger of death if live parts come into
contact with water.
Do not immerse the Aqua-Stop safety
device in water (it contains an electric
valve).
Caution!
Water damage
The connection points for the water
supply and water drainage hoses are
under high pressure. To prevent
leakage or water damage, always follow
the instructions in this chapter!
Notes
■
In addition to the safety information
listed here, the local water and
electricity supplier may have special
requirements.
■
Operate the washer dryer with cold
drinking water only.
■
Do not connect the washer dryer to
the mixer tap of an unpressurised
hot water boiler.
■
Use only the inlet hose supplied or
one purchased from an authorised
specialist outlet. Never use an used
one!
■
If in doubt, have the appliance
connected by a technician.
Water supply
Notes
■
Do not kink, crush, alter or cut
through the water supply hose
(otherwise, its strength can no longer
be guaranteed).
■
Only tighten the screw connections
by hand. If the screw connections
are tightened too tightly using a tool
(pliers), the threads may be
damaged.
Optimum water pressure in the mains:
100–1000 kPa (1–10 bar)
■
When the tap is turned on, the water
flow is at least 8 l/min.
■
If the water pressure is higher, install
a pressure reducing valve.
1.
Connect the water supply hose to
the tap (¾" = 26.4 mm) and to the
appliance (except models with
Aquastop):
– Standard
aFP
aFP
aFP
PLQ
FP
PD[
FP
Summary of Contents for WVH28422SN
Page 51: ...6 ...
