Bosch WTH85VS6SN, User Manual

Page: 13 / 48

Installation and connection
en
13
▶
Replace the accessories in ques-
tion before operating the appli-
ance.
→
"Accessories", Page 24
Included with
the appliance Description
Tumble dryer
Accompanying
documents
4.3 Requirements for the in-
stallation location
ATTENTION!
If the appliance is tilted at an angle
greater than 40°, residual water may
leak out of the appliance and cause
material damage.
▶
Tilt the appliance carefully.
▶
Transport the appliance in an up-
right position.
If residual water in the appliance
freezes, this may cause damage to
the appliance.
▶
Do not install or operate this appli-
ance anywhere that is liable to ex-
perience frost or outdoors.
If the appliance is operated immedi-
ately after transportation, the refriger-
ant contained in the appliance may
result in damage to the appliance.
▶
Immediately after transporting the
appliance, leave it to rest for two
hours before putting it into opera-
tion.
Installation loca-
tion Requirements
On the floor Place the appli-
ance on a clean,
level and firm
surface.
Align the appli-
ance
→
Page 14 .
In a washer-dryer
stack Only use the ori-
ginal connection
set from the
dryer manufac-
turer when set-
ting up this appli-
ance in a
washer-dryer
stack.
→
"Accessories",
Page 24
→ "Accessories",
Page 24
This appliance
must only be
stacked on a
washing machine
from the same
manufacturer.
The depth and
width of this ap-
pliance must cor-
respond with the
dimensions of
the washing ma-
chine.
Do not place the
washer-dryer
stack on a plat-
form.
Against a wall Do not trap the
hoses and power
cord between the
wall and the ap-
pliance.