Bosch WTH85200AU, Installation And Operating Instructions Manual

Page: 14 / 40

en
Installation and connection
14
■
The dryer is levelled using the
threaded feet.
Note:
Check the alignment of the
appliance with a spirit level and
correct if necessary. Change the
height by turning the appliance feet.
All appliance feet must stand firmly
on the ground.
Incorrect alignment may cause high
noise levels, vibrations and improper
movement of the drum.
Note:
If in doubt, have the appliance
connected by a specialist.
Changing the condensation
drain
Note:
The condensation from the dryer
can either be discharged into the
condensation container or drained off
via a connection to the waste-water
system. By default, the condensation
from the dryer is discharged into the
condensation container.
Proceed as follows to change the
condensation drain:
1.
Remove the accessories from the
dryer drum.
2.
When the dryer is delivered from the
factory, the hose for discharging the
condensation into the condensation
container is fastened to the
connecting piece.
3.
Disconnect the hose from the
connecting piece and put it in the
"parked" position.
4.
Take the drain hose from the
accessories and secure it to the free
connecting piece.
Push the drain hose into the hose
guide.