22
9
WARNING
BEFORE USING YOUR DRYER
Read and follow all installation and operating
instructions.
Check the machine. Never connect the utilities (power or
water) to or start a damaged machine! Contact Customer
Service!
Check to be sure the dryer drain hose is installed
properly.
Turning the dryer on and off
The rotating Program Selector turns the dryer on as
drying cycle is selected and off when the selector is later
turned to the vertical
Off
position.
Before using the dryer for the first time
1.
Read these operating instructions carefully.
2.
Check that the supply voltage corresponds with the
voltage specifications on the rating plate on the dryer,
see top rear side of the dryer and/or rating plate label
inside the dryer door.
Electrical Connections; Page 16
3.
Remove all objects from the drum.
4.
Check the dryer for visible damage. If damage found
contact your dealer.
5.
Wipe the inside of the drum with a damp cloth.
6.
Check heating system.
7.
If the dryer does not work, switch the dryer to
Off
.
Look in the Troubleshooting section of the operating
instructions for support.
Temporary disconnection of the dryer
If you intend to go on vacation or are not using your dryer
for an extended period of time, you should:
1.
Turn off the circuit breaker.
2.
Pull out the power supply plug if possible.
3.
Clean the lint filter.
Using program selector to choose a
drying cycle
NOTICE:
If the Child lock is activated, you must
deactivate it before you can select a program.
Use the program selector to select the desired drying
program. The dial turns in both directions and when a
cycle is selected its time duration appears in the display.
@
Lint filter
H
Air inlet
P
Open the maintenance flap
Close the maintenance flap
Condenser
