12
INSTALLATION INSTRUCTIONS
Installation Instructions
READ AND SAVE THESE INSTRUCTIONS
Introduction
Read these installation instructions completely and
carefully before starting to install your new dryer. The
information contained can save you time and effort and
will help to ensure optimum performance of your new
dryer. Be sure to observe all warnings and cautions.
9
WARNING
RISK OF FIRE, ELECTRIC SHOCK OR INJURY TO
PERSONS
▯
To reduce the risk of fire, electric shock or injury
to persons, read the Important Safety Instructions
at the beginning of this manual before installing
or operating this appliance.
▯
To reduce the risk of severe injury or death, follow
all installation instruction.
▯
Clothes dryer installation must be performed by a
qualified installer, according to these instructions
and according to all local codes.
▯
In addition to the installation and safety
information in this manual, the local water and
electric authorities (services) may have special
requirements that must be followed.
▯
Install the clothes dryer according to these
manufacturer’s instructions and local codes.
▯
Your dryer is supplied with a specific power
adapter that is only to be used with the Bosch
Washers and Dryers having NEMA 6-15P cords.
Any other use of this power adapter is prohibited.
Read and follow the Important Safety Instructions
supplied with the Power Adapter.
9
CAUTION
▯
The appliance is heavy. Do not lift it by yourself,
use additional help and care when lifting and
positioning.
▯
If in doubt, have the appliance installed by an
authorized service provider.
▯
Take care to not damage the appliance. Do not
hold on to protruding parts (e.g. door) when
lifting. Do not push against the appliance door
glass due to risk of damage.
▯
Do not install the appliance outdoors or in an
area exposed to freezing conditions.
▯
If freezing conditions exist where appliance is
located all drain water must be removed from
hoses, sumps, pumps, etc.
▯
Hidden surfaces may have sharp edges. During
service wear gloves and use caution when
reaching inside the dryer housing.
These installation instructions are intended for use by
qualified installers. In addition to these instructions, the
installation must comply with:
▯
for the United States - National Electrical Code, ANSI/
NFPA70 - and latest editions of the state and
municipal and/or local regulations.
▯
for Canada - Canadian Electrical Code C22.1 - and the
latest editions of the provincial, municipal and/or local
regulations.
Before installing the dryer
Unpacking the appliance
9
CAUTION
Remove the appliance packaging carefully to
prevent damage to the surfaces.
After removing the packaging, immediately remove
all objects from the drum.
Check the dryer for transportation damage. Do not
connect the utilities (power or drain) to a dryer which is
visibly damaged. If in doubt, contact your dealer.
