Help with the appliance
en
59
3
Help with the appliance
Help with the appliance
Faults
Cause/remedy
The appliance will not start.
Check the mains plug and the fuses.
Creasing.
■
Load exceeded or incorrect programme selected for a type of fabric.
All the required information can be found in the programme table.
■
Remove laundry from the drum as soon as the drying programme has
finished. Creasing occurs when clothing is left in the drum.
Water is leaking out.
■
The appliance may be positioned at an angle. Level the appliance.
■
In the base unit, make sure that:
– The heat exchanger cover is properly locked.
– There is no dirt or debris on the heat exchanger cover's seal.
■
If the optional drain hose* is installed, make sure that the drain hose
The programme does not start Make sure that:
■
The door is closed
■
The
E
3sec (Child lock) has been deactivated
■
You have pressed
A
(Start/Pause)
Note:
If the programme has been delayed by setting
ñ
(ready in), the
programme starts at a later point.
If
à•‹˜
is shown on the display for five seconds after you switch the
appliance on or off, this means that the appliance is in shop mode.
Switch shop mode off as follows:
1.
Switch the appliance off and then on again.
2.
Wait until the
à•‹˜
message goes out in the display.
3.
Press and hold
A
(Start/Pause) for at least five seconds.
‹””
appears in the display and the appliance switches itself off
automatically. Shop mode is now deactivated and you can use the
appliance as normal.
Programme duration displayed
changes as drying progresses.
Not a fault. The moisture sensor measures the residual moisture in the
laundry and adjusts the programme duration (with the exception of timed
programmes).
www.devicemanuals.eu
Summary of Contents for WT45N202GB
Page 66: ...6 www devicemanuals eu ...
Page 67: ...6 www devicemanuals eu ...
