Inspection and servicing
6720814332 (2018/04)
43
11.15 Inspection and maintenance reports
Inspection work
Date:
____________
Date:
____________
Date:
____________
Date:
____________
Date:
____________
Date:
____________
1.
Check the general condition of the heating system.
2.
Carry out a visual inspection and function check of the heating
system.
3.
Check the system components in contact with gas and water
for the following:
• tightness during operation
• visible signs of corrosion
• signs of ageing.
4.
Check the burner, ignition and monitoring electrodes.
5.
Measure the gas supply pressure.
______ mbar ______ mbar ______ mbar ______ mbar ______ mbar ______ mbar
6.
Measure gas/air ratio
_______ Pa
_______ Pa
_______ Pa
_______ Pa
_______ Pa
_______ Pa
7.
Carry out a tightness test during operation.
8.
Measure the CO content (flue gas analysis).
_______ ppm _______ ppm _______ ppm _______ ppm _______ ppm _______ ppm
9.
Measure the ionisation current.
_______ μA
_______ μA
_______ μA
_______ μA
_______ μA
_______ μA
10. Check the charge pressure:
– Check the charge pressure of the heating system.
_______ bar
_______ bar
_______ bar
_______ bar
_______ bar
_______ bar
11. Check the combustion air supply and flue gas routing.
12. Check that the control is set correctly.
▶ Consult the instruction manual of the controller.
13. Final inspection check, take measurements and document
measurement and test results.
Confirm correct inspection
Company stamp/signature/date
Table 18 Inspection and maintenance reports
Summary of Contents for Worcester GB162-100 V2
Page 49: ...6720814332 2018 04 49 Notes ...