Bosch WNG2540KGR, Instruction Manual And Installation Instructions

Page: 20 / 56

en
Positioning and connecting
20
Before washing for the first
time
The appliance was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Βαμβακερά (Cottons) 90°C
programme the first time
without
laundry.
Note:
■
The appliance must have been
installed and connected properly.
~
"Positioning and connecting"
on page 13
■
Never switch on a damaged
appliance.
1.
Insert mains plug.
2.
Turn the water tap on.
3.
Close the door. Do not load any
laundry.
4.
Select the
Βαμβακερά (Cottons)
90°C
programme.
5.
Open the detergent drawer.
6.
Pour approx. 1 litre of water into
dispenser II.
7.
Add standard detergent to dispenser
II according to manufacturer’s
instructions for light soiling.
Note:
To prevent frothing, use only
half the recommended amount
of detergent. Do not use any
woollens or mild detergents.
8.
Close the detergent drawer.
9.
Select
Έναρξη / Προσθήκη ρούχων
(Start/Reload)
.
10.
When the programme ends, turn the
programme selector to
Off
.
Your appliance is now ready for use.
Transportation
e.g. when moving home
Preparatory work:
1.
Turn off the water tap.
2.
Reduce the water pressure in the
supply hose.
~
Page 45
3.
Drain any residual water.
~
Page 44
4.
Disconnect the appliance from the
mains.
5.
Remove the hoses.
6.
Empty the dispensers.
Caution!
Risk of damage to the appliance
caused by detergent/fabric softener
leaking from the dispensers
Leaking detergent/fabric softener
can prevent the appliance from
working correctly, e.g. due to
damage to the electronics.
Empty the dispensers before
transporting the appliance.
Installing the transport locks:
1.
Remove the covers and keep them
in a safe place.
Note:
Use a screwdriver if
necessary.