Cleaning and maintenance
en
43
The drain hose at the siphon
is blocked
1.
Turn the programme selector to
Off
.
Pull out the mains plug.
2.
Loosen the hose clamp. Carefully
remove the drain hose; residual
water may leak out.
3.
Clean the drain hose and siphon
connecting piece.
4.
Re-attach the drain hose and secure
the connection point using the hose
clamp.
Filter in the water supply is
blocked
Release water pressure in the supply
hose:
1.
Turn off the water tap.
2.
Select the
Cottons
(activate
(
SpeedPerfect
setting)
programme.
Note:
If your appliance with
intelligent dosing system
*
, you also
need to deactivate the intelligent
dosing system.
3.
Select the
A
Start/Reload
button.
Allow the programme to run for
approx. 40 seconds.
4.
Turn the programme selector to
Off
.
5.
Pull out the mains plug.
Clean the filters:
1.
Disconnect the hose from the rear of
the appliance.
2.
Use pliers to remove the filter.
3.
Clean the filter with a small brush.
4.
Connect the hose and check for
leaks.
* Depending on the model
