en
Appliance settings
40
Removing laundry/switching
off the appliance
1.
Set programme selector to
Û
(Off)
.
2.
Open the door and remove the
laundry.
3.
Turn off the water tap.
Note:
Not required for Aqua-Stop
models.
Notes
■
Do not leave any items of laundry in
the drum. They may shrink in the
next wash or discolour another item.
■
Remove any foreign objects from the
drum and the rubber seal – risk of
rusting.
■
Wipe the rubber seal dry.
■
Leave the door and detergent
drawer open so that any residual
water can evaporate.
■
Always wait until the programme
ends, as the appliance could still be
locked. Then switch the appliance
on and wait for it to unlock.
Q
Appliance settings
Appliance settings
You can change the following settings:
■
The volume of the end signal.
■
The volume of the button signal.
■
Switching the drum care information
signal on/off.
You will need to activate the setting
mode in order to change these settings.
Activate setting mode:
1.
Set the programme selector to
position 1. The appliance is switched
on.
2.
Touch and hold the
0
Centrif. (Spin
Speed)
button and, at the same
time, turn the programme selector
clockwise to position 2. Release the
0
Centrif. (Spin Speed)
button.
The setting mode is activated and the
preset setting appears in the display
panel.
Changing the volume and drum care
information
Use the
Terminado en/em (Finish in/
Time Dry)
button to change the
following settings at the corresponding
programme selector positions:
■
2: The volume of the end signal.
■
3: The volume of the button signals.
■
4: Switching the drum care
information signal on/off.
Exiting setting mode
You can now end the process and set
the programme selector to the
Û
(Off)
position. The settings are saved.
1/2/3/4...
positions on the
programme selector
0 = off, 1 = quiet,
2 = medium, 3 = loud,
4 = very loud
Ž
on
Œ
off
