Operating the appliance
en
39
Adding/removing laundry
After starting the programme (only for
washing), you can add or remove
laundry if necessary.
Touch the
A
Start/Reload
button. The
appliance checks whether reloading is
possible.
If the following appears on the display
panel:
■
The symbol
Õ
disappears,
reloading is possible.
■
The symbol
Õ
lights up, reloading is
not possible.
To continue the programme, touch the
A
Start/Reload
button. The
programme continues automatically.
Notes
■
Do not leave the door open for too
long when adding laundry as water
from the laundry may leak out.
■
For safety reasons, the door remains
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
1.
Touch the
A
Start/Reload
button.
2.
Select another programme.
3.
And touch the
A
Start/Reload
button again. The new programme
starts from the beginning.
Note:
If drying is activated, you can
change the programme by programme
selector directly.
Cancel the programme
For programmes washing at high
temperatures:
1.
Touch the
A
Start/Reload
button.
2.
To cool down laundry: Select
Rinse
O
.
3.
Touch the
A
Start/Reload
button.
For programmes washing at low
temperatures:
1.
Touch the
A
Start/Reload
button.
2.
Select
0
[
Spin/Drain
.
3.
Touch the
A
Start/Reload
button.
For programmes in drying process:
1.
Turn the programme selector to any
other programme.
2.
Wait a few minutes to cool down
laundry, then the door will be
unlocked.
Programme end
“Ÿš
lights up on the display and
~
and
Õ
displays are off.
If you have selected
2
, the water is only
drained after rinse process, no spin
cycle.
Notes
■
If
•©£
flashes in the display before
the drying programme ends, the
temperature in the drum is high. The
programme for cooling the drum
runs until the temperature in the
drum has dropped.
■
If you do not take laundry out within
15 mins after drying process
finished, wrinkle guard process will
start to prevent laundry getting
wrinkled. The process lasts about 30
minutes.
0:00,
£‘˜
,
£©
and
“Ÿš
will
be displayed alternately on the
display and
V
symbol will be
displayed as the status symbol. You
can touch any button to terminate
this process, then the door will be
released and laundry can be taken
out.
