Bosch WLK24261BY, Instruction Manual And Installation Instructions

Page: 39 / 42

Positioning and connecting
en
39
9.
Pour approx. 1 litre of water into
dispenser
II
.
10.
Add standard detergent to
dispenser
II
according
to manufacturer’s instructions for
light soiling.
Note:
To prevent frothing, use only
half the recommended amount of
detergent. Do not use any woollens
or mild detergents.
11.
Close the detergent drawer.
12.
Select
Start
/Reload.
13.
At the end of the programme set the
programme selector to
Off
.
Your washing machine is now ready to
use.
Transportation
Preparatory work
1.
Turn off the tap.
2.
Reduce the water pressure in the
supply hose. Cleaning and
maintenance – Clean the water inlet
filter
~
Page 27
3.
Drain the remaining detergent
solution. Cleaning and maintenance
– Drain pump blocked
~
Page 26
4.
Disconnect the washing machine
from the mains.
5.
Remove the hoses.
Installing transportation protection
devices:
1.
Remove the covers and keep in a
safe place.
If required, use a screwdriver.
2.
Insert all 4 sleeves.
Clamp the mains cable on the
holders. Insert and tighten the bolts.
Before switching on the appliance:
Notes
■
The transport locks
must
be
removed!
~
Page 34
■
To prevent unused detergent from
flowing into the outlet during the next
wash: Pour 1 litre of water into
dispenser
II
and start the
0
[
Spin/
Drain
programme: (if only a drained
cycle is required: set rpm (spin
speed) to - - -).