Bosch WLK20261BY, Instruction Manual

Page: 20 / 38

en
Setting the signal
20
– Always wait until the programme
ends, as the appliance could still
be locked. Switch the appliance
on and wait for the unlocking
device.
– If at the end of the programme
the display has gone out, the
energy saving mode is active. To
activate, select any button.
M
Setting the signal
Set ti ng the si gna l
1. Activate setting mode for the signal volume
turn to Off hold down + and turn one position to
the right
press and hold the button for approx. five
seconds until the display elements light up
Setting mode is activated.
2. Set the volume for the button signals (depending on model)
press the button until the required volume is
reached
go to
point 3. or
set to Off , which exits setting mode for the
signal volume
3. Set the volume for the information signals
rotate it one step to the
right
press the button until the required volume is
reached
set to Off , which exits setting
mode for the signal volume