en
Home Connect
42
Activate Flex Start
Activate the Flexstart function to allow
the energy manager to start your ap-
pliance once your home photovoltaic
system is able to provide sufficient
energy or the energy tariff is good.
Requirement:
The appliance is con-
nected to the energy manager.
1.
Set the programme you require.
2.
Press
- Finish in
+
to set the re-
quired time period.
3.
Press
Start/Reload
.
4.
Press
Start/Reload
.
a
If the display shows , the Flex-
start is activated.
a
If the time changes on the display,
e.g. to 8 h, the energy manager
has established a time at which
your appliance can start.
a
If the energy manager does not
start the programme within the set
time, the appliance starts the pro-
gramme itself. The programme
ends at the set time.
Note
Flex Start is deactivated for safety
reasons in the following
circumstances:
¡
Press
Start/Reload
.
¡
Open the appliance door.
¡
Switch off the appliance.
¡
Power cut.
15.5 Activating Wi-Fi on the
appliance
Note:
When Wi-Fi is activated, the en-
ergy consumption increases in com-
parison to the values specified in the
consumption value table.
1.
Press and hold
Remote Start
for
approx. 3 seconds.
2.
Set the programme to position 4.
a
The display shows
Con
.
3.
Press
Start/Reload
repeatedly
until the display shows
On
.
a
Wi-Fi is activated.
Note:
If Wi-Fi is activated, the appli-
ance will not switch itself off automat-
ically.
15.6 Deactivating Wi-Fi on the
appliance
1.
Press and hold
Remote Start
for
at least three seconds.
2.
Set the programme to position 4.
a
The display shows
Con
.
3.
Press
Start/Reload
repeatedly
until the display shows
OFF
.
a
Wi-Fi is deactivated.
Note:
The connection is automatically
re-established when the Wi-Fi is
switched back on.
15.7 Software update
Requirement:
The display shows
UPd
1.
Press and hold
Remote Start
for
approx. 3 seconds.
2.
Set the programme to position 6.
a
UPd
appears on the display.
3.
Press
Start/Reload
.
a
The software update is installed.
a
If
End
is shown on the display, the
software update is installed.
Note:
Do not switch off the appliance
while the software update is in pro-
gress.
15.8 Resetting the appliance
network settings
1.
Press and hold
Remote Start
for
at least 3 seconds.
2.
Set the programme to position 5.
a
The display shows
rES
.
