5.6
Customer fault displays
(from Operating Instructions)
Problem
Possible cause
Remedial action
Water faucet not turned
on.
Turn water faucet on. Cycle
will continue.
Water hose kinked or
pinched.
Straighten out or replace hose,
if damaged.
Water hose filters
(strainers) clogged.
Clean hose filters (strainers).
AQUA
STOP
®
hose has
tripped.
If hose indicator shows
red
,
replace hose.
“Check water tap!”
Low water pressure.
Open water faucet fully or
increase water pressure to
washer.
Suds occurred (from too
much or wrong detergent).
For future loads, use less
detergent and use a detergent
for front loading washers (with
“HE” on the package).
“Suds or blocked
pump?”
Drain pump is blocked.
Clean drain hose and drain.
“Check door!”
Door not closed properly.
Check for laundry trapped in
door. Re-close door securely.
“Aquastop activated”
AQUA
STOP
®
float has
triggered (due to water in
washer base).
Shut off water and check for
leak, including all connections.
Soak up water from washer
base.
5.7 Customer
maintenance
5.7.1 Cleaning hose strainers
Water hose strainers (filters) should be cleaned every six months,
especially in areas with hard water, or when water flows more slowly
into washers. Strainers are cleaning by placing hose ends under
running water.
Water pressure in hoses should be released by turning faucets off,
selecting any
warm
water wash cycle, pushing the
Start/Pause
button
and waiting 30 seconds and finally by turning the washer program
knob to
Off
. Using a warm water cycle drains both hot and cold water
hoses.
702_58300000143607_ara_en_a
Page 38 of 42
