en
Cleaning and maintenance
58
Note:
To prevent unused detergent
from flowing straight into the drain
during the next wash, pour 1 litre of
water into compartment
v
u
and start
the
[
Drain
programme.
The drain hose at the siphon
is blocked
1.
Switch off the appliance. Pull out the
mains plug.
2.
Loosen the hose clamp. Carefully
remove the drain hose; residual
water may leak out.
3.
Clean the drain hose and siphon
connecting piece.
4.
Re-attach the drain hose and secure
the connection point using the hose
clamp.
Filter in the water supply
blocked
First, reduce the water pressure in the
supply hose:
1.
Turn off the tap.
2.
Select any programme
(except Rinse/Spin/Empty).
3.
Press the
A
button. Allow the
programme to run for approximately
40 seconds.
4.
Press the
#
button. The appliance is
switched off.
5.
Pull out the mains plug.
Then clean the filter:
1.
Disconnect the hose from the tap.
Clean the filter with a small brush.
2.
For standard and Aqua-Secure
models, clean the filter on the rear of
the appliance:
Remove the hose from the rear of
the appliance.
Use pliers to remove the filter and
then clean it.
3.
Connect the hose and check for
leaks.