Additional programme settings
en
19
2.
Press the
Finished in
button
repeatedly until the required number
of hours is displayed.
Note:
The setting values are
increased using the
Finished in +
button, and decreased using the
Finished in -
button.
3.
Press the
A
button.
The programme starts.
The selected number of hours
(e.g.
8 h
) is shown in the display
panel and counts down until the
wash programme starts. The
duration of the programme is then
displayed.
Note:
The length of the programme is
automatically adjusted when the
programme is running. Changes to the
default programme settings or
programme settings may also change
the programme duration.
After starting the programme
(if a
Finished in time has been selected and
the wash programme has not yet
started), you can change the
preselected number of hours as follows:
1.
Press the
A
button.
2.
Use the
Finished in -
or
+
button to
change the number of hours.
3.
Press the
A
button.
After starting the programme
, you can
add or remove laundry if necessary.
\
Additional programme
settings
Add
it
ion
al
pr
ogr
amme
set
ti
ngs
An overview of all additional settings,
which can be selected depending on
the programme, can be found from
.
EcoPerfect
F
Energy-optimised washing by reducing
the temperature while achieving a
washing result that is consistent with the
selected programme, without the
EcoPerfect
F
setting.
SpeedPerfect
G
Washing in a shorter time while
achieving a washing result that is
consistent with, but uses more energy
than, the selected programme, without
the SpeedPerfect
G
setting.
Note:
Do not exceed the maximum
load.
Overview of programmes
Easy-iron
p
Reduces creasing thanks to a special
spin sequence followed by fluffing and
reduced spin speed.
Note:
The washing's residual moisture
is increased.
Water Plus
Z
Higher water level and additional rinse
cycle for particularly sensitive skin and/
or for areas with very soft water.
