Home Connect
en
43
4.
Press
Start / Reload
.
a
The display shows and Flex
Start is activated. The appliance
waits to be started by the smart
energy system (energy manager).
a
If the time changes on the display,
e.g. to 8 h, the smart energy sys-
tem (energy manager) has estab-
lished a time at which your appli-
ance can start.
a
If the smart energy system (energy
manager) does not start the appli-
ance within the set time, the appli-
ance will start the programme itself
before the set time period ends.
The programme ends when the
time period ends.
Note
Flex Start is deactivated for safety
reasons in the following circumstances:
¡
Press
Start / Reload
.
¡
Open the door.
¡
Switch off the appliance.
¡
Power failure.
Activating Wi-Fi on the appli-
ance
Note:
When Wi-Fi is activated, the en-
ergy consumption increases in com-
parison to the values specified in the
consumption value table.
1.
Press and hold
Remote Start
for
approx. 3 seconds.
2.
Set the programme to position 4.
a
The display shows
Con
.
3.
Press
Start / Reload
repeatedly
until the display shows
On
.
a
Wi-Fi is activated.
Note:
If Wi-Fi is activated, the appli-
ance will not switch itself off automat-
ically.
Deactivating Wi-Fi on the appli-
ance
1.
Press and hold
Remote Start
for
at least three seconds.
2.
Set the programme to position 4.
a
The display shows
Con
.
3.
Press
Start / Reload
repeatedly
until the display shows
OFF
.
a
Wi-Fi is deactivated.
Note:
If Wi-Fi is switched off and your
appliance was previously connected
to your home network, this connec-
tion will be re-established automatic-
ally when Wi-Fi is switched back on.
Software update
Requirement:
The display shows
Upd
.
1.
Press and hold
Remote Start
for
approx. 3 seconds.
2.
Set the programme to position 6.
a
UdP
appears on the display.
3.
Press
Start / Reload
.
a
The software update is installed.
a
If
End
is shown on the display, the
software update is installed.
Note:
The software update may take
several minutes. Do not switch off the
appliance while the software update
is in progress.
Resetting the appliance network
settings
1.
Press and hold
Remote Start
for
at least 3 seconds.
2.
Set the programme to position 5.
a
The display shows
rES
.
3.
Press
Start / Reload
.
a
The display shows
YES
.
4.
Press
Start / Reload
.
a
The network settings are reset.
Summary of Contents for WAV28L40SG
Page 63: ......
