en
Cleaning and servicing
44
Cleaning the water outlet
hose at the siphon
If the water outlet hose at the siphon
is dirty or the detergent solution is
not being pumped out, you must
clean these.
1.
Switch off the appliance.
2.
Disconnect the appliance's mains
plug from the power supply.
3.
Loosen the hose clamp and care-
fully remove the water outlet hose.
Residual water may leak out.
4.
Clean the water outlet hose and si-
phon connecting piece.
5.
Reattach the water outlet hose and
secure the connection point using
the hose clamp.
Clean the water inlet filters.
Clean the filter in the water inlet in
the event of blockages or if the water
pressure is too low.
Emptying the water inlet hose
1.
Turn off the tap.
2.
Set a programme, except for
,
or .
3.
Start the programme and leave it
to run for approx. 40 seconds.
4.
Switch off the appliance.
5.
Disconnect the appliance's mains
plug from the power supply.
Cleaning the filter on the tap
Note:
Please read the information in
the "Safety" →
sec-
tions to ensure that you use the appli-
ance safely.
Requirement:
The water inlet hose is
empty.
1.
Remove the water inlet hose from
the tap.
Summary of Contents for WAU28T40ES
Page 46: ...en Cleaning and servicing 46 2 1 ...
Page 59: ......
