Operating the appliance
en
35
Starting the programme
Touch and hold
Start/Reload
A
button
for 1~2 seconds, then release the
button. The programme starts and the
appliance door is locked.
The
ñ
Finished in
is shown in the
display panel and counts down until the
programme starts. After the programme
has started, the programme duration is
displayed. And the displays for the
programme's progress light up.
Note:
Foam detection
If the symbol
Å
also lights up in the
display panel, the appliance has
detected too much foam during the
wash cycle and automatically activated
additional rinse cycles to remove the
foam.
If you want to lock the programme to
prevent it from being adjusted
inadvertently, you can select the
childproof lock.
Childproof lock
You can lock the appliance to prevent
the settings you have set from being
changed inadvertently. To do this,
activate the childproof lock.
To activate the childproof lock:
After the programme starts, Touch and
hold the
0
rpm
and
ñ
Finished in
buttons for 3 seconds. The symbol
E
lights up in the display panel.
■
E
lights up: The childproof lock is
activated.
■
E
flashes: If the programme and
programme settings are adjusted
while childproof lock is activated.
Note:
When the programme ends,
End
is displayed. The door is unlocked.
E
symbol remain on to remind you to
deactivate the childproof lock.
To deactivate the childproof lock:
Touch and hold the
0
rpm
and
ñ
Finished in
buttons until the symbol
E
disappears.
Adding/removing laundry
After starting the programme, you can
add or remove laundry if necessary.
Touch the
Start/Reload
A
button. The
appliance checks whether reloading is
possible.
If the following appears on the display
panel:
■
The symbol
Õ
disappears, reloading
is possible.
■
The symbol
Õ
lights up, reloading is
not possible.
To continue the programme, touch the
Start/Reload
A
button. The
programme continues automatically.
Notes
■
Do not leave the door open for too
long when adding laundry as water
from the laundry may leak out.
■
For safety reasons, the door remains
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
1.
Touch the
Start/Reload
A
button.
2.
Select another programme.
3.
And touch the
Start/Reload
A
button again. The new programme
starts from the beginning.
Summary of Contents for WAU28490AU
Page 51: ...6 ...
