Faults and what to do about them.
en
41
Information on the display panel
Indicator
Cause/remedy
è
off
The door is unlocked at the end of the programme or when paused, laundry can be
added/removed
è
is lit up
■
During the programme. Door locked.
■
Paused: Temperature too high. Wait until the temperature drops.
■
Paused: Spin speed too high. Wait until the drum comes to a halt.
■
Paused: Water level too high. It is not possible to add laundry. Touch
A
to
continue the programme.
è
flashes
■
Slowly: The door cannot currently be locked or unlocked. Waiting time
required.
■
Quickly: Close the door because water can flow out from the laundry.
è
and the ActiveOx-
ygen
Refresh
Ø
indicator
light flash
The door cannot be opened due to programme-related technical reasons.
When the lights go off, the door can be opened.
A
off
At the end of the programme, while the door is open
A
is lit up
After the programme has started
A
is flashing
Before the programme starts, paused
r
is lit up
Water pressure too low, may increase the length of the programme.
r
is flashing
No water supply:
■
Turn the tap on fully,
■
The supply hose is kinked/trapped,
■
Clean the filter if necessary.
E
3 sec is lit up
The childproof lock is activated – deactivate it.
E
3 sec is flashing
The childproof lock is activated – the programme selector has been turned or the
control panel touched.
Û
is flashing
Run the
Drum Clean 90 °C
programme or a 60 °C programme to clean and care
for the drum and the outer tub.
Notes
■
Run the programme without laundry.
■
Use standard washing powder or a detergent that contains bleach. To prevent
foaming, only use half the amount of detergent recommended by the detergent
manufacturer. Do not use detergents intended for woollens or delicates.
■
Switching the information signal on/off
Å
is lit up
Too much foam has been detected and additional rinse cycles have been activated.
Add less detergent to the next wash cycle with the same load.
