en
Cleaning and maintenance
32
4.
Take the drain hose out of the
retainer.
Remove the sealing cap and pour
the water out into a suitable
container.
Replace the sealing cap and place
the drain hose back in the retainer.
5.
Carefully unscrew the pump cover;
residual water may leak out.
Clean the interior, pump-cover
thread and pump housing. The
impeller in the drain pump must be
able to rotate.
Refit the pump cover and screw it on
tightly. The handle must be in a
vertical position.
6.
Put the service flap back on, lock it
into place and close it.
Note:
To prevent unused detergent
from flowing straight into the drain
during the next wash, pour 1 litre of
water into compartment
u
v
and start
the
Empty
programme.
The drain hose at the siphon
is blocked
1.
Switch off the appliance. Pull out the
mains plug.
2.
Loosen the hose clamp. Carefully
remove the drain hose; residual
water may leak out.
3.
Clean the drain hose and siphon
connecting piece.
4.
Re-attach the drain hose and secure
the connection point using the hose
clamp.
Filter in the water supply
blocked
First, reduce the water pressure in the
supply hose:
1.
Turn off the tap.
2.
Select any programme (except
Rinse/Spin/Empty).
3.
Press the
A
button. Allow the
programme to run for approximately
40 seconds.
4.
Press the
#
button. The appliance is
switched off.
5.
Pull out the mains plug.
Then clean the filter:
1.
Disconnect the hose from the tap.
Clean the filter with a small brush.
