6 000 836 999
2013-05-08
|
Bosch Automotive Diagnostics Equipment (Shenzhen) Limited
16|��������|Maintenance
en
8.
Maintenance
!
Work on electrical equipment is only to be per-
formed by persons with sufficient knowledge and
experience of electrical systems.
8.1
Importantnotesonmaintenance
!
Before starting maintenance work under raised lift-
ing platform components, these are to be secured to
prevent unintentional movement.
!
In the event of breakage of a loadbearing compo-
nent, the loadbearing structures and drive system
including the safety devices are to be examined to
prevent falling or lowering of the loadbearing ele-
ment. Damaged parts are to be replaced.
i
The replacement of suspension cables is to be re-
corded in the test log book.
8.�
Cleaning
!
The lifting platform safety devices are not to be
replaced or bypassed during cleaning.
!
Always raise the lifting platform when cleaning the
floor area with detergent.
The lifting platform is only to be cleaned using water
containing a small quantity of neutral or slightly alka-
line detergent. The water temperature must not exceed
25 °C. The components can be wiped with soft cloths
or sponges. Rinse components with clean water after
cleaning.
!
Never use cleaning agents which corrode paintwork,
coatings or sealing materials:
R
No solvents (esters, ketones, alcohols, halogenated
hydrocarbons)
R
No abrasive cleaning agents (scouring powder)
R
No acidic or highly alkaline cleaning agents
!
Never clean the lifting platform with high-pressure or
steam cleaners.
i
A
preservative agent
(e.g. commercially available
transparent cavity sealant) provides extra protection
for the coating. This should be applied in all areas
with exposed edges or where moisture may ingress.
This does not apply to the top edge of the runway.
8.�
Replacementandwearingparts
Spareparts/Component
Ordernumber
High pressure hose(pump)
1 697 090 100
High pressure hose(secondary col-
umn)
1 697 090 101
High pressure hose(main column)
1 697 090 102
Steel rope
1 697 090 103
Main oil cylinder
1 697 090 104
Pump
1 697 090 002
Operation box
1 697 090 105
Quick
service
package
Rear sliding block
1 697
090 003
1 697 090 007
Front sliding block
1 697 090 006
Anti-collision rubber
1 697 090 008
Fuse
1 697 090 009
Breaker
1 697 090 010
Main switch
1 697 090 011
Press button
1 697 090 012
Spring
1 697 090 108
Oil cylinder seal suit
1 697 090 005
Height limit switch 8106
1 697 090 014
Height limit switch 8166
1 697 090 107
Rubber element for
mount
1 697 090 015
8.4
Maintenancebytheuser
The maintenance work described below must be per-
formed by the user.
!
Prior to maintenance, the platform must always be
disconnected from the mains and secured to prevent
unauthorized use.
!
If components are damaged or worn or do not func-
tion properly:
Inform Bosch customer service or an authorized
service agent.
8.4.1
Maintenanceagreement
i
Regular upkeep of the lifting platform is essential to
ensure a long service life and permanent readiness
for use. We recommend concluding a maintenance
agreement with Bosch customer service or an au-
thorized service agent.
