VIP XD
| Installation and User Guide
EN
| 17
Bosch Security Systems | 2005-05 | V1.0
Installation
Alarm inputs
The VIP XD has four alarm inputs on the orange terminal block (for pin
assignment, see page 76). The alarm inputs are used to connect to external
alarm devices, such as door contacts or sensors. With the appropriate
configuration, an alarm sensor can, for example, trigger an automatic
connection between the VIP XD and a particular transmitter.
A voltage free contact or switch can be used as an actuator.
Note
If possible, use a bounce-free contact system as the actuator.
– Connect the lines to the appropriate terminals on the orange terminal block
(
IN1
to
IN4
) and check that the connection is secure.
Relay output
The VIP XD has a relay output for switching external devices, such as lights or
audible alarms. This relay output can be activated manually during a connection
session with the VIP XD. Moreover, the output can be configured to activate
audible alarms or other devices as a response to an alarm signal. The relay
output is also located on the orange terminal block (for pin assignment see
page 76).
Warning!
The maximum rating of the relay contact is 30 V and 2 A.
– Connect the lines to the appropriate terminals (
R
) on the orange terminal
block and check that the connection is secure.
