Installation and User Guide |
VIP XD
EN
| 16
Installation
Bosch Security Systems | 2005-05 | V1.0
Connections
Monitors
If required, you can connect an analog video monitor (PAL/NTSC) or a VGA-
compatible computer monitor.
– Connect an analog video monitor to the BNC jack
Video Out
with a video
cable (75 Ohm, BNC connector)
or
– Connect a VGA compatible computer monitor to the Sub-D jack
VGA
with a
video cable (VGA, 15-pin Sub-D connector).
Data interface
The bi-directional data interface is used to transmit control data for a unit
connected to the VIP XD, such as a control panel for dome cameras.
The interface supports the RS232, RS422 and RS485 transmission standards.
The serial interface is made up of four terminals of the ST500 jack (for pin
assignment see page 76).
The manufacturers of the relevant equipment can provide specific information
on installation and operation.
Warning!
Refer to the associated documentation when installing and operating the
control unit. This contains important safety instructions and information
about permitted uses.
Note
A video connection is necessary to transmit transparent data.
Network
You can connect the VIP XD to a 10/100 Base-T network. Use a standard UTP
Category 5 cable with RJ45 connectors for this.
– Connect the unit to the network using the
ETH
jack.
