Bosch Stora BP 1000 E, Installation And Service Instructions Manual

Page: 19 / 40

Regulations
19 Stora – 6721835329 (2021/04)
2.3 Product description
Table 17 Product description (

Fig. 1 - 3, page 33 - 34)
2.4 Type Plate
Table 18 Type Plate
2.5 Tech data
Table 19 Tech data
2.6 Product data for energy consumption
The following product data satisfy the requirements of the
EU Regulations No. 811/2013 and No. 812/2013 supplementing
EU Regulation 2017/1369.
Manufacturers who implement these guidelines and state the ErP values
are permitted to use the "CE" mark.
Table 20 Product data for energy consumption
3 Regulations
Observe the following guidelines and standards:
• Local regulations
•
EnEG (Building Regulations) (in Germany)
• EnEV (in Germany)
Installation of, and equipment for, heating and water heating systems:
• DIN and EN standards
– EN 12828 – Heating systems in buildings - Design and installation
of DHW heating systems
– DIN 18380 – German construction contract procedures (VOB) -
Installation of central heating systems and hot water supply
systems
– DIN 18381 – German construction contract procedures (VOB) -
Installation of gas, water and drainage systems inside buildings
– EN 16297, Part 1/2 – Centrifugal pumps - Wet running heating
pumps
• VDE regulations
Product data for energy consumption
• EU Regulation and Directives
– EU Regulation 2017/1369
– EU Regulation 811/2013 and 812/2013
Pos. Description
1 Heating water inlet
2 Heating water outlet
3 Rigid foam thermal insulation
4 Vent valve
5 Foil jacket
6 Data plate
7 Heating water outlet
8 Heating water inlet
9 Installation options, electric heating
10 Installation options, electric heating
11 Installation options, electric heating
12 Installation options, electric heating
13 Installation options, electric heating
14 Installation options, electric heating
15 Sensor pocket at bottom (only with BP 1000 E)
16 Sensor pocket at centre (with BP 200 EK+BP 500 EP
accessory)
17 Sensor pocket at top (with BP 200 EK+BP 500 EP accessory)
18 Inspection aperture (only with BP 500 EP)
Pos. Description
1 Type designation
2 Serial number
3 Nominal volume
4 Nominal volume of heat exchanger
5 Standby heat loss
6 Corrosion protection
7 Year of manufacture
8 Maximum DHW temperature, cylinder
9 Maximum flow temperature, heat source
10 Maximum flow temperature, solar side
11 Heating water heat input
12 Volumetric flow rate of heating water for heating water input
power
13 Maximum operating pressure on the domestic water side
14 Highest design pressure
15 Maximum operating pressure, heat source side
16 Maximum operating pressure, solar side
17 Maximum operating pressure on the domestic water side CH
18 Maximum test pressure on the domestic water side CH
Unit BP 200 EK BP 500 EP BP 1000 E
Dimensions and specifications -

Fig. 4 - 6, page 35 - 36
Memory
Available capacity l 199 480 867
Maximum heating water temperature °C 95 95 95
Maximum operating pressure of heating water bar 3 6 3
Standby heat loss (24 h) in accordance with DIN 4753 Part 8
1)
1) Excluding distribution losses outside the cylinder.
kWh/24 h 1.22 2.41 3.22
Product
number Product type Cylinder
volume
(V)
Heat
retention
loss (S)
Energy
efficiency class
for DHW
treatment
8735100973 BP 200 EK 1 B 199,4 l 50,7 W B
8735100974 BP 500 EP 1 C 480,0 l 100,5 W C
8735100978 BP 1000 E 1 C 867,0 l 134,0 W C