Bosch SPV68L00GB, Operating Instructions Manual

Page: 22 / 30

en
22
... when the appliance is
switched on
The appliance does not start.
– The mains fuse has tripped.
– The appliance plug has not been
inserted.
– The appliance door has not been shut
properly.
... changing settings
A setting cannot be changed, a
programme starts.
– Wrong programme button pressed.
Terminate the programme (see chapter
entitled “Terminating the programme
(Reset)”) and start all over again.
– You did not wait until programme
ended.
... on the appliance
Lower spray arm rotates sluggishly.
– Spray arm blocked.
The door is difficult to open. *
– Child-proof lock is activated. The
deactivation instructions are at the
back in the envelope.
* depending on model
Door cannot be closed.
– Door lock has been activated. To reset,
close the door with greater force.
Cover on the detergent dispenser cannot
be closed.
– Detergent dispenser overfilled or
mechanism blocked by sticky
detergent residue.
Detergent residue in the detergent
dispenser.
– Dispenser was damp when filled.
“Check water supply” display
8
lights
up.
– Tap turned off.
– Water supply interrupted.
– Supply hose kinked.
– Filter in the water supply blocked.
– Switch off the appliance and pull
out the mains plug.
– Turn off the tap.
– Clean filter in the supply hose.
– Reconnect power supply.
– Turn on the tap.
– Switch on the appliance.
–
Water is left in the appliance
at the end of the programme.
– (
“
:
ƒ…
) Waste water hose
is blocked or kinked.
Filters blocked.
– (
“
:
Ġ
) Waste water pump blocked,
cover on the waste water pump
is not locked in position
(see Waste water pump).
– Filters blocked.
– The programme has not yet ended.
Wait until programme ends (digital
display indicates
‹
:
‹‹
) or
implement the “Reset” function.
Error code
“
:
ƒƒ
– Filters
1R
are soiled or blocked.
Refill indicator for salt
@
and/or rinse-
aid
H
is not lit.
– Refill indicator/s switched off.
– Adequate salt/rinse-aid available.
Refill indicator for special salt
@
is lit.
– No salt.
Refill with special salt.
– Sensor does not detect salt tablets.
Use different special salt.