NLRinse System
– A higher setting adds more rinse
aid during the wash cycle,
reducing water spots and
improving drying results.
max
5.
To save the settings, press . for
about 3 seconds
to press.
Switch off rinse system
3.
If rinse aid has spilled over, it must
be removed from the rinse aid
container.
If the rinse aid refill indicator bothers
you, e.g. if you use a combined
dishwasher detergent with a rinse aid
component, you can switch off the
rinse system.
Rinse aid spilled over can cause
excessive foaming during the wash
cycle.
4.
Close the lid of the rinse aid
reservoir.
Tip:The function of the rinse aid is
limited in combination detergents. You
usually get better results by using
rinse aid.
aThe lid audibly clicks into place.
Set the rinse aid amount
If streaks or water spots remain on the
dishes, adjust the amount of rinse aid.
1.
Press.
2.
Approx. 3 seconds on
to access the basic settings.
Busy-
1.
Press.
aThe display shows Hxx. aThe
display shows
2.
Approx. 3 seconds on
to access the basic settings.
Busy-
reflected
to give.
3.
Just as often on
until the display shows the factory
set value r05.
to press
aThe display shows Hxx. aThe
display shows
reflected
to give.
3.
Just as often on
until the display shows the factory
set value r05.
to press
4.
Just as often on
press until
the display shows r00.
5.
To save the settings, press . for
about 3 seconds
to press.
aThe rinse aid system is
switched on and the rinse aid refill
indicator is deactivated.
4.
Just as often on
press until
the desired amount of rinse aid
has been set.
– At a low setting, less
rinse aid during the
added, where-
on the crockery
less.
wash cycle allowed
through the stripes
be well
28
