Troubleshooting
en
51
Fault
Cause
Troubleshooting
Water is left in the appliance
at the end of the pro-
gramme.
Programme has not yet
ended.
▶
Wait until the programme ends or
cancel the programme with
Reset
.
▶
Appliance cannot be
switched on or operated.
Software update is taking
place.
▶
Wait until the software update has
finished.
Appliance functions have
failed.
1.
Pull out the mains plug or switch off
the fuse.
2.
Wait at least 2 minutes.
3.
Connect the appliance to the power
supply.
4.
Switch the appliance on.
Appliance does not start.
The mains fuse has tripped.
▶
Check the relevant fuse.
Mains cable is not inserted.
1.
Check whether the socket works.
2.
Check whether the mains cable is
properly inserted in the socket and
on the rear of the appliance.
Appliance door is not closed
properly.
▶
Close the appliance door.
Programme starts automat-
ically.
You did not wait until pro-
gramme ended.
▶
Appliance stops during the
programme or cuts out.
Appliance door is not closed
properly.
▶
Close the appliance door.
Power and/or water supply
has been interrupted.
1.
Check the power supply.
2.
Check the water supply.
Top basket is pressing
against inner door and pre-
venting appliance door from
being closed securely.
▶
Check whether the rear panel of the
appliance is being pressed in by a
socket or hose holder that has not
been removed.
▶
Arrange the tableware so that no
parts project beyond the basket
and prevent the appliance door
from closing properly.
Mechanical damage
Fault
Cause
Troubleshooting
Appliance door cannot be
closed.
Door lock has been activ-
ated.
▶
Close the appliance door with
greater force.
