Bosch SMS 53N18, Operating Instructions Manual

Page: 17 / 28

en
17
Timer programming
Timer programming *
* depending on model
You can delay the start of the programme
in 1-hour steps up to 24 hours.
–
Close the door.
– Switch on ON/OFF switch
(
.
– Press button
@
+ until the digital
display
)"
jumps to
œ
:
‹‚
.
– Press
@
+ or – button until the
displayed time corresponds with your
requirements.
– Press START button
P
, timer
programming is activated.
– To delete timer programming, press
the
@
+ or – button until
)"
œ
:
‹‹
is
indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
End of programme
The programme has ended when the
value
‹
:
‹‹
is indicated on the numerical
display
)"
.
Switching off automatically after t he end of the programme
Switching off automatically after
the end of the programme *
* depending on model
To save energy, the dishwasher is
switched off 1 minute after the programme
ends (factory setting).
Automatic disconnection can be adjusted
from
˜
:
‹‹
to
˜
:
‹ƒ
.
– Close the door.
– Switch on ON/OFF switch
(
.
– Hold down programme button
#
and
press START button
P
until
•
:
‹
... is
indicated on the digital display.
– Release both buttons.
The LED for button
#
flashes and the
digital display
)"
displays the factory
setting
•
:
‹…
.
– Press programme button
#
until the
factory set value
˜
:
‹‚
is indicated on
the digital display
)"
.
To change the setting:
– Press programme button
3
.
Each time the button is pressed, the
set value increases by one level; when
the value of
˜
:
‹ƒ
has been reached,
the display jumps back to
˜
:
‹‹
(off).
– Press START button
P
.
The set value is saved.
Switching off the appliance
Short time after the end of the programme:
–
Switch off ON/OFF switch
(
.
– Turn off the tap (not applicable if Aqua-
Stop fitted).
– Remove the utensils when they have
cooled down.
ã=
Warning
At the end of the programme please open
the door fully and not partially when
emptying the dishwasher. Any escaping
water vapour could damage sensitive
worktops.
Interrupting the programme
– Switch off ON/OFF switch
(
.
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave the
door ajar for several minutes and then
close. Otherwise, expansion (pressure)
may cause the appliance door to
spring open or water to run out of the
appliance.
– To continue the programme, switch on
the ON/OFF switch
(
again.
Terminating the programme
Terminating the programme
(Reset)
– Press START button
P
for
approx. 3 sec.
The numerical display
)"
indicates
‹
:
‹‚
.
– The programme sequence lasts
approx. 1 min. On the digital
display
)"
is indicated
‹
:
‹‹
.
– Switch off ON/OFF switch
(
.
˜
:
‹‹
Appliance does not switch off
automatically
˜
:
‹‚
Off after 1 min
˜
:
‹ƒ
Off after 120 min