en
18
Spray arms
Limescale and contaminants in the rinsing
water may block nozzles and bearings on
the spray arms
1:
and
1B
.
–
Check outlet nozzles on the spray arms
for blockages.
–
Unscrew the upper spray arm
1:
.
–
Remove the lower spray arm
1B
upwards.
–
Clean spray arms under running water.
–
Re-engage or screw on spray arms.
Waste water pump
Large food remnants in the rinsing water
not retained by the filters may block the
waste water pump. The rinsing water is
then not pumped out and covers the filter.
In this case:
–
First disconnect the appliance from the
power supply.
–
Remove the filters
1R
.
–
Scoop out water, use a sponge if
required.
–
Using a spoon, prise off pump cover
(as illustrated) until it clicks, then grip
the cover by the lug and first pull it
upwards until it resists and then pull it
out forwards.
–
Check inner compartment and remove
any foreign objects.
–
Place cover in the original position,
press down and engage.
–
Install filters.
1
2
1
2
3
Klick
