en
Detergent
16
2.
Close the cover on the detergent
dispenser by sliding it up until the
lock engages without difficulty.
The detergent dispenser opens
automatically at the optimum time
depending on the programme.
The powder or liquid detergent is
distributed in the appliance and is
dissolved. The tablet falls into the
appliance and dissolves.
Tip
If the utensils are only lightly soiled,
slightly less than the indicated amount
of detergent is usually adequate.
Suitable detergents and care products
can be purchased online
via our website or via customer service
(see back page).
Combination detergent
Apart from conventional detergents
(Solo), a number of products are offered
with additional functions. These
products contain not only the detergent
but also rinse-aid and salt replacement
substances (3in1) and, depending
on the combination (4in1, 5in1, etc.),
additional components such as glass
protection or stainless steel cleaner.
Combination detergents function only
up to a specific degree of hardness
(usually 26° Clarke). Over this limit salt
and rinse-aid must be added.
As soon as combined detergents
are used, the rinse programme
is adjusted automatically to ensure
the best possible rinsing and drying
result.
Notes
ヽ
You will obtain optimum rinsing
and drying results by using solo
detergents and applying salt and
rinse aid separately.
ヽ
If programmes are short, tablets
may not have full cleaning effect
due to different dissolving properties
and there may even be undissolved
detergent residue. It is
recommended to use washing
powder for these programmes.
ヽ
Even if the rinse-aid and/or salt refill
indicator is lit, the rinse programme
will run correctly with combined
detergents.
ヽ
If using detergents in a water-soluble
protective cover: Take hold of the
cover with dry hands only and put
the detergent into an absolutely
dry detergent dispenser only,
otherwise the detergent may stick.
ヽ
If you switch from combined
detergents to solo detergents,
ensure that the water softening
system and amount of rinse aid have
been set to the correct value.
&/,&.
