702_58300000170749_ara_en_c
Page 59 of 82
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary
information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
11. Reinstall heat / drain pumps and drain hose.
12. Install parts into top of sump, including suction cap and
drain pump cover.
CAUTION:
Tank edges are sharp! Use gloves, cover
tank edges and install sump carefully.
5.16 Drain hose
5.16.1
Removing drain hose
Tools needed: #2 Phillips & small flat blade screwdrivers.
1.
Disconnect & pull out dishwasher
– section 5.1.5.1.
2.
Remove water valve
– section 5.5.1. Don’t completely
remove the valve, just remove the valve and support
from the base so the hose can slide out.
3. Pull drain hose out from water level control
(below left)
.
4. Slide the drain hose to the right to remove it from the base
(below right)
. The hose is notched to be held by the base
and can’t be pulled straight out.
5.16.2
Removing sump drain hose
Tools needed: #2 Phillips & small flat blade screwdrivers.
1.
Disconnect & pull out dishwasher
– section 5.1.5.1.
2. Pull out the drain hose w/ O-ring from the sump
(below
left)
and from the water level control
(below right)
.
5.17 Info Light (selected models)
Tools needed: T20 Torx & small flat blade screwdrivers.
1.
Remove outer door
– section 5.1.2.1.
2. Disconnect wire harness from info light.
3. Remove the info light by carefully snapping it out from the
right hinge plate.
