en-us
Operating the Dishwasher
30
Delay start
You can delay the start of the cycle in
one hour increments up to 24 hours.
To set Delay start:
1.
Press
On/Off
button
(
. Select a
cycle.
2.
Press
Delay
button
@
until the
displayed time corresponds with
your requirements.
3.
Press
Start
button
P
to activate
Delay start.
To cancel Delay start:
1.
Press
Delay
button
@
until
œ
:
‹‹
is indicated on the digital
display
8
.
2.
Press
Start
button
P
to save
setting.
Note:
Your dishwasher is protected
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Close the appliance door
and press the Start button
P
again.
Wash cycle end
The wash cycle has ended when the
display
8
reads
‹‹
:
‹‹
.
Auto power off
To save energy, the dishwasher is
turned off 1 minute after the wash
cycle ends.
This setting can be adjusted from
˜
:
‹‹
to
˜
:
‹ƒ
.
To change the setting:
1.
Press the
On/Off
button
(
.
2.
Hold down the function key
#
and press the
Start
button
P
until the display
8
indicates
š
:
‹
x (x can be any number).
3.
Release both buttons.
4.
Press the function key
#
until
the display
8
indicates
˜
:
‹
x.
5.
Press the function key
3
until
the display corresponds with your
requirements.
6.
Press the
Start
button
P
.
Switching off the appliance
Short time after the end of the wash
cycle:
1.
Press
On/Off
button
(
.
2.
Turn off water supply.
3.
Remove the utensils when they
have cooled down.
9
WARNING
RISK OF INJURY!
To avoid risk of injury, always
use caution when opening the
door during or following a wash
cycle as hot water or steam
may escape. Do not fully open
the door until water noises have
stopped and steam has
subsided.
œ
:
‹‚
1 hour delay
œ
:
ƒ…
24 hours delay
˜
:
‹‹
dishwasher does not turn off
automatically
˜
:
‹‚
dishwasher turns off
automatically after 1 minute
˜
:
‹ƒ
dishwasher turns off
automatically after
120 minutes (2 hours)
