NL Rinse System
2.
Top up the rinse aid up to the max
mark.
– A low setting adds less rinse aid
during the wash cycle, reducing
the streaks on the dishes.
– A higher setting adds more rinse
aid during the wash cycle,
reducing water spots and
improving drying results.
max
5.
To save the settings, press for
approx. 3 seconds.
3.
If rinse aid has spilled over, it must
be removed from the rinse aid
container.
Switch off the rinse system
Rinse aid spilled over can cause
excessive foaming during the wash
cycle.
If the rinse aid refill indicator bothers
you, e.g. if you use a combined
dishwasher detergent with a rinse aid
component, you can switch off the
rinse aid system.
4.
Close the lid of the rinse aid
reservoir.
a The lid audibly clicks into place.
Set rinse aid amount
Tip: The function of the rinse aid is
limited in combined detergents. You
usually get better results by using
rinse aid.
If streaks or water spots remain on
the dishes, adjust the amount of rinse
aid.
1.
on
to press.
1.
on
to press.
2.
Approx. 3 seconds on
to access the basic settings.
Busy-
2.
Approx. 3 seconds on
to access the basic settings.
Busy-
a The display shows Hxx.
a The display shows
a The display shows Hxx.
reflected
a The display shows
to give.
to give.
3.
Press just as often
until the display shows the
factory-set value r05.
3.
Just as often on
to press
until the display shows the
factory-set value r05.
4.
Press as many times until
the display shows r00.
4.
Press as many times until
the desired amount of rinse aid
has been set.
5.
To save the settings, press for
approx. 3 seconds.
a The rinse aid system is
switched on and the rinse aid
refill indicator is deactivated.
26
