NL Softening System
3. Note: Only use special salt for
dishwashers.
Do not use salt tablets. Do not
use table salt.
according to the manufacturer's
instructions, only use up to a
degree of hardness of 21 °dH
without adding softening salt.
Place the softening salt in the
softening salt reservoir.
s The water hardness is 0 - 6
°dH. You don't need softening salt
to use.
1.
on
to press.
2.
Approx. 3 seconds on
Busy-
a
to access the basic settings.
a The display shows Hxx.
a The display shows
to give.
3.
Press as many times until
the display shows H00.
4.
To save the settings, press for
approx. 3 seconds.
a The water softener has been
switched on and the refilling salt
indicator is deactivated.
Funnel
1
Fill the water softening salt
reservoir completely with softening
salt. The water in the reservoir is
displaced and flows away.
4.
Fit and close the lid of the
reservoir.
Regenerate the softening
system
Switch off water softening
In order to maintain trouble-free
operation of the softening system,
the device regularly performs a
regeneration of the softening system.
The softening system is regenerated
in all programs before the end of the
main wash cycle. This increases the
running time and the consumption
values of, for example, water and
electricity.
If the refilling salt display bothers you,
for example if you use a combined
dishwasher detergent with a salt
component, you can switch off the
display.
Remark
To avoid damage to the appliance,
only switch off the water softening
in the following cases:
s
The water hardness is a maximum
of 21 °dH and you use a combined
dishwasher detergent with salt
substitutes. You can use
combination detergents with salt
substitutes
1
Depending on the device version
24
