Water softening system / special salt
en-us
13
+
Water softening
system / special salt
Water softening system / special salt
To ensure good rinsing results, the
dishwasher requires soft water, i.e.
water which is low in lime, otherwise
limescale will be deposited on the
utensils and interior container. Tap
water above 7° dH (1.2 mmol/l)
must be softened. The water
is softened with special salt
(regeneration salt) in the water
softening system of the dishwasher.
The setting and therefore the
required amount of salt depends on
the degree of hardness of your tap
water (see following water hardness
table).
Water hardness table
Adjusting the water
softening system
The amount of salt dispensed can be
set from
•
:
‹‹
to
•
:
‹ˆ
. Salt is not
required at the set value
•
:
‹‹
.
Set the softening system as follows:
1.
Ask your local water utility
company for the water hardness
value of your tap water or use test
strip.
2.
Required setting can be found in
the water hardness table.
3.
Press
On/Off
button
(
.
4.
Hold down function key
#
and
press
Start
button
P
until the
display
8
indicates
•
:
‹
x (x can
be any number).
5.
Release both buttons.
The indicator of function key
#
flashes and the display
8
indicates
•
:
‹‹
. Press function key
3
to select the desired setting.
6.
Press
Start
button
P
to save
the setting.
The chosen setting has now been
stored.
¯¯
¯³
¯
¯´
¯
¯
¯±
¯Å
:DWHUKDUG
QHVVYDOXH
*UDLQVJDOORQ
JSJ
VRIW
PHGLXP
KDUG
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
PPROO
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
:DWHU
VRIWHQHU
VHWWLQJ
+DUGQHVV
UDQJH
KDUG
KDUG
PHGLXP
PHGLXP
VRIW
Summary of Contents for SGE53X52UC
Page 2: ...2 ...
