
226
en | System menus and dialogs
Security Escort
2017.08 | V2.18.1.0 | DOC
Training Manual
Robert Bosch (SEA) Pte Ltd
Slave Database path
The path that this master or workstation computer uses to
access the hot backup database files on the slave computer. This
path may have a different drive letter on the different master and
workstation computers. They are usually on the slave computer,
but they may be on a file server or any other network accessible
drive. Typically, they would not be stored on the same computer
as the
Master Database path
, so a single failure would not
prevent access to both the master and slave database files.
Note: With version 2.04 or above of the software, it is possible
to use UNC path names instead of mapping drive letters.
Therefore, the path to the slave computer
’
s database would be
“\\SLAVE\ESCORT”.
Local Escort path
The path on this workstation where the Security Escort was
installed in. Typically it is “C:\ESCORT”.
Other Backup/Restore path
When backing up the database to or restoring it from external
disks, this is the path that is used.
Subscriber image file path
The Security Escort System software can display an image for
each subscriber on the alarm screen. This parameter tells the
software the path where the image files are stored. The default
is “C:\ESCORT\IMAGES”.
Extension
The subscriber images can be in JPEG or Windows Bitmap
format. All images in a system must be in the same format. For
the JPEG format, enter the Windows extension “JPG”. For the
Bitmap format, enter the Windows extension “BMP”.
Scaling %
When the display is set to 640x480 pixels, and subscriber images
are being displayed, this parameter controls the image size. This
value can range from 10 to 100%, and should be adjusted while
viewing alarms to get the desired image size. When the display is
set to 800x600 or larger (recommended), this parameter has no
effect.
[Save]
Clicking this button saves the changes and closes the dialog
window.
[Cancel]
Clicking this button aborts the changes and closes the dialog
window.
8.5.2
Network Socket Status Dialog
This dialog shows diagnostic information for the selected TCP/IP socket.